The solution is proper belt tension, or, in this case, an almost lack thereof. The best method, while a bit tedious, is to sneak up on the correct tension. Start with a very loose setting. If you can move the
So now we address the question of: What is the correct belt tension for these bushing type generators?. You should tighten the fan belt just enough so the belt does not slip on the generator pulley.
The belt needs to be re-tensioned often, for some reason. The upper generator bolt for the sliding adjuster is difficult to reach, and there is very little room for a ratchet or other tool to
This diagram illustrates how to replace a serpentine belt on an engine. It shows the various components including the power steering pump, generator,...
The tensioner pulley has a hexagon hole to fit an allen key to tension the belt. If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Up to$7cash back· Check the drive belt tension by the following procedure. Gently tap the middle of the belt between the pulleys (the location indicated by the arrow) with your finger as
Place the belt tension gauge onto the Second Stage Drive Belt midway between the Generator/Brake pulley and larger Step-up Assembly pulley and measure the tension.
The generator is mounted with a bolt through two brackets on the generator. No matter how I tighten things, over time the generator moves making the fan belt a bit loose.
Though I never could see it, My belt tensioner was wobbling and allowing the bando belt to slip off a bit. After I got a gates belt, the pulley actually sawed the belt down from 6 to 3 ribs.
Use a tension gauge to check the belt tension. Press the center of the belt between the pulleys shown in the illustration with a force of 98N (22 lb) to check the belt deflection.
PDF version includes complete article with source references. Suitable for printing and offline reading.
